–{•¶‚ÖƒXƒLƒbƒv

ƒwƒ‹ƒXƒPƒA•ª–ì‚ƈًƎí‚Æ‚Ì‹«ŠE—̈æÅ“K‰»

ƒT[ƒrƒX‚Æ‹ZpServices & Solutions

Toppage > 3D Printer > COVID-19 > Full Face Respirator


Full Face Respirator

Full Face Respirator

Remodel Full face respirator

COVID-19 is a respiratory infection. Ingestion of the virus from the nose and mouth causes symptoms such as pneumonia.

Conversations during meals are at high risk of infection.
However, you can get infected without talking face-to-face.

The protection with a surgical mask or face shield is not perfect.

When a high concentration of virus is scattered, there is a possibility that it will enter through the gaps in the protective equipment.

Therefore, we developed a face shield to protect medical personnel.

It is a mask that can be fitted with a particulate filter.


Remodel Full Face Respirator with 3D Printer (Japanese)





Wearing procedure

Full Face Respirator

Start with the chin

Hold the rubber band with both hands and hang the bottom edge of the mask on the wearer's chin.


Full Face Respirator

Like wearing a hat

Put on the rubber band by pulling it down on the back of your head like wearing a hat.


Full Face Respirator

Positioning

Align the full face respirator.

Since the mouth and nose breathing parts are separate rooms inside the mask, fit it so that it covers the nose and mouth nicely.

Also, if the outer circumference does not fit the face exactly, it may cause air leakage and suck unnecessary air.


Full Face Respirator

Rubber band

Pull the left and right lower rubber bands to make the mask fit your face tightly.

The rubber band is a consumable item.


Full Face RespiratorFull Face Respirator





Preparation work

Full Face Respirator

connector

The air supply connector on the top of the full face respirator should be brought into close contact with the O-ring (rubber packing), then the latch should be hooked and the lever should be pulled down until it snaps into place.

Visually check the close contact with the O-ring.


Full Face Respirator

HEPA filter

You can optionally install a HEPA filter.

Insert it into the connector with a slight rotation and check that it does not get stuck.





Features of the full face respirator

NES News

Modified snorkel mask (scuba gear)

The base of this full face respirator is a snorkel mask (scuba gear).

It is designed to have high adhesion so that water does not enter.

The air is taken in from above the surface of the water, and the air is exhaled underwater.
Applying that system, the supply air passes through the filter.

Breathable HEPA filter can be installed

The connector size is adjusted so that various HEPA filters used as artificial noses and particulate filters can be installed.

Two designs, single type and dual type

Generally, only one ventilation port is required, but we also have two types for those who may move violently.





Health professionals reviewed this

NES News

Medical doctor checked this

This product has been evaluated by a clinician.







—×{ZŠÂ‹«Å“K‰»E‹­xZŠÂ‹«
ƒuƒ‰ƒbƒNƒAƒEƒg•a‰@‚a‚b‚o(‘Sˆæ’â“dˆã—ÃBCP)
¡ŒŽ‚̃Cƒ`ƒIƒV(NES)

«@L@«

ª@L@ª